ISO 8739-1997
Grooved pin, full length parallel grooved with pilot
ISO 8740-1997
Grooved pins-Full-length parallel grooved with chamfer
ISO 8741-1997
Grooved pins-Half-length reverse-taper grooved
ISO 8742-1997
Grooved pins-One-third-length centre grooved
ISO 8743-1997
Grooved pins--Half-length centre grooved
ISO 8744-1997
Groovd pins-Full-length taper grooved
ISO 8745-1997
Grooved pins-half-length taper grooved
ISO 8746-1997
Grooved pins with round head-type A
ISO 8746-1997
Grooved pins with round head-type B
ISO 8747-1997
75°Grooved pins with countersunk head-type A
ISO 8747-1997
75°Grooved pins with countersunk head-type B
ISO 8739-1986
Grooved pin, full length parallel grooved with pilot
ISO 8740-1986
Grooved pins-Full-length parallel grooved with chamfer
ISO 8741-1986
Grooved pins-Half-length reverse-taper grooved
ISO 8742-1986
Grooved pins-One-third-length centre grooved
ISO 8743-1986
Grooved pins--Half-length centre grooved
ISO 8744-1986
Groovd pins-Full-length taper grooved
ISO 8745-1986
Grooved pins-half-length taper grooved
ISO 8746-1986
Grooved pins with round head-type A
ISO 8746-1986
Grooved pins with round head-type B
